null

Accessories Unlimited Cb Antenna

What You Should Know about mount's,

 

Ground reflections is one of the common types of multipath. The radiation pattern and even the driving point impedance of an antenna can be influenced by the dielectric constant and especially conductivity of nearby objects. For a terrestrial antenna, the ground is usually one such object of importance. The antenna's height above the ground, as well as the electrical properties  and conductivity) of the ground, can then be important. Also, in the particular case of a monopole antenna, the ground (or an artificial ground plane) serves as the return connection for the antenna current thus having an additional effect, particularly on the impedance seen by the feed line.

 

When an electromagnetic wave strikes a plane surface such as the ground, part of the wave is transmitted into the ground and part of it is reflected, according to the Fresnel coefficients. If the ground is a very good conductor then almost all of the wave is reflected (180° out of phase), whereas a ground modeled as a (lossy) dielectric can absorb a large amount of the wave's power. The power remaining in the reflected wave, and the phase shift upon reflection, strongly depend on the wave's angle of incidence and polarization. The dielectric constant and conductivity (or simply the complex dielectric constant) is dependent on the soil type and is a function of frequency.

 

For very low frequencies to high frequencies (< 30 MHz), the ground behaves as a lossy dielectric, thus the ground is characterized both by a conductivity (dielectric constant) which can be measured for a given soil (but is influenced by fluctuating moisture levels) or can be estimated from certain maps. At lower frequencies the ground acts mainly as a good conductor, which AM middle wave broadcast (0.5–1.6 MHz) antennas depend on.At frequencies between 3 and 30 MHz, a large portion of the energy from a horizontally polarized antenna reflects off the ground, with almost total reflection at the grazing angles important for ground wave propagation. That reflected wave, with its phase reversed, can either cancel or reinforce the direct wave, depending on the antenna height in wavelengths and elevation angle (for a sky wave).

How Douse Radiation And Pattern,

The radiation pattern of an antenna is a plot of the relative field strength of the radio waves emitted by the antenna at different angles in the far-field. It is typically represented by a three-dimensional graph, or polar plots of the horizontal and vertical cross sections. The pattern of an ideal isotropic antenna, which radiates equally in all directions, would look like a sphere. Many nondirectional antennas, such as monopoles and dipoles, emit equal power in all horizontal directions, with the power dropping off at higher and lower angles; this is called an omnidirectional pattern and when plotted looks like a torus or donut.

The radiation of many antennas shows a pattern of maxima or "lobes" at various angles, separated by "nulls", angles where the radiation falls to zero. This is because the radio waves emitted by different parts of the antenna typically interfere, causing maxima at angles where the radio waves arrive at distant points in phase, and zero radiation at other angles where the radio waves arrive out of phase. In a directional antenna designed to radio waves in a particular direction, the lobe in that direction is designed larger than the others and is called the "main lobe". The other lobes usually represent unwanted radiation and are called "sidelobes". The axis through the main lobe is called the "principal axis" or "boresight axis".

The polar diagrams (and therefore the efficiency and gain) of Yagi antennas are tighter if the antenna is tuned for a narrower frequency range, e.g. the grouped antenna compared to the wideband. Similarly, the polar plots of horizontally polarized yagis are tighter than for those vertically polarized,

What Is Efficiency Separate From Impedance Matching,

 

reduce the amount of power radiated using a given transmitter. If an SWR meter reads 150 W of incident power and 50 W of reflected power, that means 100 W have actually been absorbed by the antenna (ignoring transmission line losses). How much of that power has actually been radiated cannot be directly determined through electrical measurements at (or before) the antenna terminals, but would require (for instance) careful measurement of field strength. The loss resistance and efficiency of an antenna can be calculated.

The loss resistance will generally affect the feedpoint impedance, adding to its resistive component. That resistance will consist of the sum of the radiation resistance Rr and the loss resistance Rloss. If a current I is delivered to the terminals of an antenna, then a power of I2 Rr will be radiated and a power of I2 Rloss will be lost as heat. Therefore, the efficiency of an antenna is equal to ​Rr⁄(Rr + Rloss). Only the total resistance Rr + Rloss can be directly measured.

According to reciprocity, the efficiency of an antenna used as a receiving antenna is identical to the efficiency as defined above. The power that an antenna will deliver to a receiver (with a proper impedance match) is reduced by the same amount. In some receiving applications, the very inefficient antennas may have little impact on performance. At low frequencies, for example, atmospheric or man-made noise can mask antenna inefficiency. For example, CCIR Rep. 258-3 indicates man-made noise in a residential setting at 40 MHz is about 28 dB above the thermal noise floor. Consequently, an antenna with a 20 dB loss (due to inefficiency) would have little impact on system noise performance. The loss within the antenna will affect the intended signal and the noise/interference identically, leading to no reduction in signal to noise ratio (SNR).

Antennas which are not a significant fraction of a wavelength in size are inevitably inefficient due to their small radiation resistance. AM broadcast radios include a small loop antenna for reception which has an extremely poor efficiency. This has little effect on the receiver's performance, but simply requires greater amplification by the receiver's electronics. Contrast this tiny component to the massive and very tall towers used at AM broadcast stations for transmitting at the very same frequency, where every percentage point of reduced antenna efficiency entails a substantial cost.

The definition of antenna gain or power gain already includes the effect of the antenna's efficiency. Therefore, if one is trying to radiate a signal toward a receiver using a transmitter of a given power, one need only compare the gain of various antennas rather than considering the efficiency as well. This is likewise true for a receiving antenna at very high (especially microwave) frequencies, where the point is to receive a signal which is strong compared to the receiver's noise temperature. However, in the case of a directional antenna used for receiving signals with the intention of rejecting interference from different directions, one is no longer concerned with the antenna efficiency, as discussed above. In this case, rather than quoting the antenna gain, one would be more concerned with the directive gain, or simply directivity which does not include the effect of antenna (in)efficiency. The directive gain of an antenna can be computed from the published gain divided by the antenna's efficiency,

  • Flexible fiberglass whip with "tunable tip" that allows for fine tuning SWR and resonant frequency.

200 Watt antenna whip
1/4" Diameter tapered fiberglass construction
Chromed brass ferrule & standard 3/8" x 24 threads
Exclusive dark gray color
Design incorporates 22 gauge "silver plated" wire to provide higher efficiency
The "tunable tip" allows for fine tuing SWR resonant frequency
Unique ground lead to help insure reduced static and ignition interference
Static reducing weather cap
Clamshell

    Wilson FLEX-4 4' Flexible Fiberglass Antenna

    Patterned after the proven performance of the Wilson FGT fiberglass antennas, the Wilson Flex antenna out performs all similar types of top loaded flex fiberglass antennas. It is designed specifically for the CB user requiring an antenna that will take...

    $27.99
    Add to Cart
  • Large 10 oz. magnet
300 Watts Power handling capability (ICAS)
Made with high impact thermoplastic
Heavy-duty coil uses 14 gauge copper wire
Low loss coil design
36" 17-7 PH stainless steel whip

    Wilson LITTLE WIL 36" Magnet Mount Antenna

    The "Little Wil" uses Wilson's exclusive low loss coil design and is patterned after the proven performance of the Wilson 1000 and 500. The "Little Wil" out performs all similar types of small base loaded antennas. It was designed specifically for users...

    $37.00
    Add to Cart
  • Wilson W1000 RT 62" Roof Mount Antenna

    Wilson W1000 RT 62" Roof Mount Antenna

    This is an oversize antenna. There is an extra $8.50 handling charge on UPS shipments. The Wilson 1000's higher gain performance is a result of several new design developments that bring to you the most powerful CB base loaded antenna available in its...

    $84.99
    Add to Cart
  • Wilson W500 54" Magnet Mount cbradio

    Wilson W500 54" Magnet Mount cbradio

    The Wilson 500's higher gain performance for an economical antenna is the result of several design modifications to the famous Wilson 1000. Using the basic design of the W-1000, Wilson is able to produce a mid priced magnetic antenna with great...

    $65.00
    Add to Cart
  • 5000 Series Mobile CB Antennas
The 5000 Series is the World's most powerful base loaded mobile CB antenna.

    Wilson W5000 62" Magnet Mount Antenna

    This is an oversize antenna. There is an extra $8.50 handling charge on UPS shipments. The Wilson 5000 is the top performing base loaded CB antenna for the automobile. Wilson used the basic design of the Wilson Trucker 5000 with the exclusive low loss...

    $130.99
    Add to Cart
  • Wilson W5000 62" Roof Top Mount Antenna

    Wilson W5000 62" Roof Top Mount Antenna

    This is an oversize antenna. There is an extra $8.50 handling charge on UPS shipments. The Wilson 5000 is the top performing base loaded CB antenna for the automobile. Wilson used the basic design of the Wilson Trucker 5000 with the exclusive low loss...

    $98.00
    Add to Cart
  • 5000 AM. 20,000 SSB watts power handling capability (ICAS)
Made with high impact mobay thermoplastic
Low loss coil design
17-7 PH tapered spring stainless steel whip
Weather channel ready
Frequency range 26 MHz to 30 MHz
Removable coil for safe storage and garage entrance
Boxed

    Wilson W5000 62" Trunk Lip Mount Antenna

    This is an oversize antenna. There is an extra $8.50 handling charge on UPS shipments. The Wilson 5000 is the top performing base loaded CB antenna for the automobile. Wilson used the basic design of the Wilson Trucker 5000 with the exclusive low loss...

    $95.99
    Add to Cart
  • Workman GRK-8 Ground Plane Kit

    Workman GRK-8 Ground Plane Kit

    Eight 2 foot fiberglass radials plus mounting ring with setscrews quickly adds optional ground plane to the Bandit and Bandit II antennas.Substantially similar to the GPK-8, the Workman GRK-8 will work with virtually any vertical antenna as it mounts...

    $34.00
    Add to Cart