Created with Sketch. Created with Sketch.

Accessories Unlimited Cb Antenna

What You Should Know about mount's,


Ground reflections is one of the common types of multipath. The radiation pattern and even the driving point impedance of an antenna can be influenced by the dielectric constant and especially conductivity of nearby objects. For a terrestrial antenna, the ground is usually one such object of importance. The antenna's height above the ground, as well as the electrical properties  and conductivity) of the ground, can then be important. Also, in the particular case of a monopole antenna, the ground (or an artificial ground plane) serves as the return connection for the antenna current thus having an additional effect, particularly on the impedance seen by the feed line.


When an electromagnetic wave strikes a plane surface such as the ground, part of the wave is transmitted into the ground and part of it is reflected, according to the Fresnel coefficients. If the ground is a very good conductor then almost all of the wave is reflected (180° out of phase), whereas a ground modeled as a (lossy) dielectric can absorb a large amount of the wave's power. The power remaining in the reflected wave, and the phase shift upon reflection, strongly depend on the wave's angle of incidence and polarization. The dielectric constant and conductivity (or simply the complex dielectric constant) is dependent on the soil type and is a function of frequency.


For very low frequencies to high frequencies (< 30 MHz), the ground behaves as a lossy dielectric, thus the ground is characterized both by a conductivity (dielectric constant) which can be measured for a given soil (but is influenced by fluctuating moisture levels) or can be estimated from certain maps. At lower frequencies the ground acts mainly as a good conductor, which AM middle wave broadcast (0.5–1.6 MHz) antennas depend on.At frequencies between 3 and 30 MHz, a large portion of the energy from a horizontally polarized antenna reflects off the ground, with almost total reflection at the grazing angles important for ground wave propagation. That reflected wave, with its phase reversed, can either cancel or reinforce the direct wave, depending on the antenna height in wavelengths and elevation angle (for a sky wave).

How Douse Radiation And Pattern,

The radiation pattern of an antenna is a plot of the relative field strength of the radio waves emitted by the antenna at different angles in the far-field. It is typically represented by a three-dimensional graph, or polar plots of the horizontal and vertical cross sections. The pattern of an ideal isotropic antenna, which radiates equally in all directions, would look like a sphere. Many nondirectional antennas, such as monopoles and dipoles, emit equal power in all horizontal directions, with the power dropping off at higher and lower angles; this is called an omnidirectional pattern and when plotted looks like a torus or donut.

The radiation of many antennas shows a pattern of maxima or "lobes" at various angles, separated by "nulls", angles where the radiation falls to zero. This is because the radio waves emitted by different parts of the antenna typically interfere, causing maxima at angles where the radio waves arrive at distant points in phase, and zero radiation at other angles where the radio waves arrive out of phase. In a directional antenna designed to radio waves in a particular direction, the lobe in that direction is designed larger than the others and is called the "main lobe". The other lobes usually represent unwanted radiation and are called "sidelobes". The axis through the main lobe is called the "principal axis" or "boresight axis".

The polar diagrams (and therefore the efficiency and gain) of Yagi antennas are tighter if the antenna is tuned for a narrower frequency range, e.g. the grouped antenna compared to the wideband. Similarly, the polar plots of horizontally polarized yagis are tighter than for those vertically polarized,

What Is Efficiency Separate From Impedance Matching,


reduce the amount of power radiated using a given transmitter. If an SWR meter reads 150 W of incident power and 50 W of reflected power, that means 100 W have actually been absorbed by the antenna (ignoring transmission line losses). How much of that power has actually been radiated cannot be directly determined through electrical measurements at (or before) the antenna terminals, but would require (for instance) careful measurement of field strength. The loss resistance and efficiency of an antenna can be calculated.

The loss resistance will generally affect the feedpoint impedance, adding to its resistive component. That resistance will consist of the sum of the radiation resistance Rr and the loss resistance Rloss. If a current I is delivered to the terminals of an antenna, then a power of I2 Rr will be radiated and a power of I2 Rloss will be lost as heat. Therefore, the efficiency of an antenna is equal to ​Rr⁄(Rr + Rloss). Only the total resistance Rr + Rloss can be directly measured.

According to reciprocity, the efficiency of an antenna used as a receiving antenna is identical to the efficiency as defined above. The power that an antenna will deliver to a receiver (with a proper impedance match) is reduced by the same amount. In some receiving applications, the very inefficient antennas may have little impact on performance. At low frequencies, for example, atmospheric or man-made noise can mask antenna inefficiency. For example, CCIR Rep. 258-3 indicates man-made noise in a residential setting at 40 MHz is about 28 dB above the thermal noise floor. Consequently, an antenna with a 20 dB loss (due to inefficiency) would have little impact on system noise performance. The loss within the antenna will affect the intended signal and the noise/interference identically, leading to no reduction in signal to noise ratio (SNR).

Antennas which are not a significant fraction of a wavelength in size are inevitably inefficient due to their small radiation resistance. AM broadcast radios include a small loop antenna for reception which has an extremely poor efficiency. This has little effect on the receiver's performance, but simply requires greater amplification by the receiver's electronics. Contrast this tiny component to the massive and very tall towers used at AM broadcast stations for transmitting at the very same frequency, where every percentage point of reduced antenna efficiency entails a substantial cost.

The definition of antenna gain or power gain already includes the effect of the antenna's efficiency. Therefore, if one is trying to radiate a signal toward a receiver using a transmitter of a given power, one need only compare the gain of various antennas rather than considering the efficiency as well. This is likewise true for a receiving antenna at very high (especially microwave) frequencies, where the point is to receive a signal which is strong compared to the receiver's noise temperature. However, in the case of a directional antenna used for receiving signals with the intention of rejecting interference from different directions, one is no longer concerned with the antenna efficiency, as discussed above. In this case, rather than quoting the antenna gain, one would be more concerned with the directive gain, or simply directivity which does not include the effect of antenna (in)efficiency. The directive gain of an antenna can be computed from the published gain divided by the antenna's efficiency,

  • Rohn 25G 30' Tower No Base

    Rohn 25G 30' Tower No Base

    Includes:(2) Standard 25G 10' Sections(1) 9' 9" 25AG2 Top SectionComplete Twoer Packages Include Guys, Connections, Anchors and GroundingAdditional InformationUPCN/AWeight500.0000ManufacturerRohnCountry of OriginN/ASchematicN/ARetail PriceN/ACase...

    Add to Cart
  • Sirio 2008 8 Radial Base Station Antenna Sirio 2008 8 Radial Base Station Antenna

    Sirio 2008 8 Radial Base Station Antenna

    Type: 5/8 λ ground planeRadiation: OmnidirectionalPolarization: Linear verticalFrequency range: 26.4 ... 28.2 MHz TunableSystems: 10m-HAMGain: 1.3 dBd, 3.45 dBiBandwidth: SIRIO 2008:≥ 1.75MHz @ SWR ≤ 2SIRIO 2016:≥ 2.1MHz @ SWR ≤ 2Max...

    Add to Cart
  • Sirio 2008, 8 Base Station Antenna

    Sirio 2008, 8 Base Station Antenna

    Type: 5/8 λ ground plane Radiation: Omnidirectional Polarization: Linear vertical Frequency range: 26.4 ... 28.2 MHz Tunable Systems: 10m-HAM Gain: 1.3 dBd, 3.45 dBi Bandwidth: SIRIO 2008:≥ 1.75MHz @...

    Add to Cart
  • Sirio Performer 5000 / Turbo 5000 Sirio Performer 5000 / Turbo 5000

    Sirio Performer 5000 / Turbo 5000

    Features:CB & 10m Trucker antennaVery High power handlingTunable from 27 to 30 MHz17/7 PH tapered stainless steel whipWhip detachable for car-washElectrical DataType: trucker antennaFrequency range: 27 ... 30 MHzImpedance: 50 ΩPolarization: linear...

    Add to Cart
  • Skip Shooter Fiberglass Antenna

    Skip Shooter Fiberglass Antenna

    SkipShooter® antennas are made from a rugged solid fiberglass core and feature a flexible braid connection that reduces the chance of breakage when the antenna contacts objects while the vehicle is in motion.All SkipShooter® antennas are made in America...

    Add to Cart